Configuring Network Parameters; Configuring Snmp - ADIC SCALAR 24 Installation And Operation Manual

• Library Status — indicates whether the library is online or offline.
• Drive Status — indicates the type and quantity of tape drives in the library.
• RMU User — indicates the name and location of the user.
• Hostname — indicates the hostname used for the RMU connection.
• IP Address — indicates the IP address for the RMU connection.
• MAC Address — indicates the Media Access Control (MAC) address of the RMU. This is also
the serial number of the RMU.
• Library Serial # — indicates the library serial number. The physical serial number, which
appears on the product safety label, is embedded in this number. This number also includes the
vendor ID and the partition.
• SNMP — indicates whether the SNMP feature is on or off.
• SNMP Alerts — indicates whether the SNMP Alert notification feature is on or off.
• Library Firmware — indicates the current level of library firmware.
• RMU Firmware — indicates the current version level of RMU firmware.

Configuring Network Parameters

You can reconfigure the hostname, IP address, subnet mask, and gateway address through the RMU. This
feature requires you to login to the RMU. Refer to
1 Click the Configuration tab.
2 In the Network Configuration area, enter the new hostname, IP address, subnet mask, and gateway
address.
3 Click Submit and review your changes (indicated in red).
4 Enter your password and click Confirm to complete the procedure.
The new values are saved. Note that you may need to redirect your Web browser.

Configuring SNMP

Simple Network Management Protocol (SNMP) is a set of protocols used to manage nodes on an IP
network. You can configure the RMU to run a SNMP management application.
1 Click the Configuration tab.
2 In the SNMP Configuration area, do the following:
• To enable or disable the feature, select ON or OFF in the SNMP Enabled drop-down.
• To enable or disable SNMP alerts, select ON or OFF in the Alerts Enabled drop-down.
• In Manager, enter the SNMP server address(es). A maximum of 10 targets can be entered into this
box after SNMP has been enabled.
• In Public Name, enter the name of the read-only SNMP community.
• In Private Name, enter the name of the read/write SNMP community.
3 Click Submit and review your changes (indicated in red).
4 Enter your password and click Confirm to complete the procedure.
The new values are saved. Note that you may need to redirect your Web browser.
5 You are instructed to reboot the RMU. Click Done to reboot.
Scalar 24 Installation and Operation Guide
Logging into the RMU on page 50 for more information.
51