Configuring Network Parameters; Configuring Snmp; Downloading The Snmp Mib File; Configuring Rmu User Accounts - ADIC Scalar 100 User Manual
Quantum scalar 100: user guide
Hide thumbs
Also See for Scalar 100:
- User manual (346 pages) ,
- Quick start manual (2 pages) ,
- Release note (2 pages)
Table of Contents
Advertisement
Configuring Network Parameters
You can reconfigure the hostname, IP address, subnet mask, and gateway address through the RMU. This
feature requires you to login to the RMU. Refer to
1
Click the Configuration tab.
2
In the Network Configuration area, enter the new hostname, IP address, subnet mask, and gateway
address.
3
Click Submit and review your changes (indicated in red).
4
Enter your password and click Confirm to complete the procedure.
The new values are saved. Note that you may need to redirect your Web browser.
Configuring SNMP
Simple Network Management Protocol (SNMP) is a set of protocols used to manage nodes on an IP
network. You can configure the RMU to run a SNMP management application.
1
Click the Configuration tab.
2
In the SNMP Configuration area, do the following:
•
To enable or disable the feature, select ON or OFF in the SNMP Enabled drop-down.
•
To enable or disable SNMP alerts, select ON or OFF in the Alerts Enabled drop-down.
•
In Manager, enter the SNMP server address.
•
In Public Name, enter the name of the read-only SNMP community.
•
In Private Name, enter the name of the read/write SNMP community.
3
Click Submit and review your changes (indicated in red).
4
Enter your password and click Confirm to complete the procedure.
The new values are saved. Note that you may need to redirect your Web browser.
5
You will be instructed to reboot the RMU. Click Done to reboot.
Downloading the SNMP MIB File
The SNMP Management Information Base (MIB) file will allow an SNMP management application to
understand the SNMP traps generated by the RMU. If you are running an SNMP management application
and need the library MIB, you can download it via the RMU.
1
Click SNMP MIB in the left pane of the RMU interface.
2
Right-click Download SNMP MIB and click Save Target As.
3
Browse to your SNMP management server and click Save.
You will need to load the MIB file into the SNMP management application.
Configuring RMU User Accounts
You can add unique users to the RMU. Only one administrator account is allowed, which maintains the login
of admin.
92
Logging into the RMU
on page 91 for more information.
Using the Remote Management Unit
Advertisement
Table of Contents
