Changing Printer Defaults; Job Storage - Stratasys F170 User Manual

CHANGING PRINTER DEFAULTS

Several factory presets can be changed via the options within the Tools page. To access this page, press the
Tools button within the Navigation Menu.
The options within the Tools page are organized into 6 categories: Settings, Calibration, Maintenance, Network,
Power, and Light. The defaults specified within the following instructions are accessible via the Settings page.
To open this page press the Settings button within the Tools page.
After making the necessary adjustments to a default setting, press the Back button in the upper-left corner of the
page to exit and return to the main Settings page.

JOB STORAGE

The Keep Previous Job setting determines whether or not the printer's previous job is stored within the Job
Queue once a build is complete (see "Wait for Part" on page 79). If you're concerned about other users of your
printer seeing what you've built, this setting will prevent the printer's previous job from being accessible after the
build is complete. By default this setting is set to On, meaning that the printer's previous job file is stored within
the Job Queue making it available for re-selection upon completion of the build.
When this setting is set to Off, the printer's previous job file will be deleted from the Job Queue upon completion
of the build. The job's file will need to be resent to the printer in order to be built again.
To configure this setting, press anywhere within the Keep Previous Job row; the Keep Previous Job page will be
displayed. Use the radio buttons within this page to turn the setting On and Off as needed.
Figure 5-19: Keep Previous Job
130