Selector Shaft Seal, Removing And Installing, Left - Audi Q7 2007 Repair Manual

– Coat the outer circumference and the space between the seal‐
ing lips -arrow- on the new shaft seal with ATF.
• Installation position: The open side of the seal faces the trans‐
mission.
– Install the shaft seal with a Seal Installer - Selector Shaft Oil
Seal - T10174- . Do not tilt the seal.
– Install the selector lever. Refer to
⇒ "2.3 Selector Lever, Removing and Installing", page 126
2.5 Selector Shaft Seal, Removing and In‐
stalling, Left
Special tools and workshop equipment required
♦ Seal Installer - Selector Shaft Oil Seal - T10174-
Procedure
– Remove the multifunction transmission range switch. Refer to
⇒ "2.2 Multifunction Transmission Range Switch F125 , Re‐
moving, Installing and Adjusting", page 123
Caution
Shaft seal running surfaces on selector shaft and transmission
housing must not be damaged.
– Pry out the right selector shaft seal using a scriber or a small
screwdriver.
– Coat the outer circumference and the space between the seal‐
ing lips -arrow- on the new shaft seal with ATF.
• Installation position: the open side of the seal faces the trans‐
mission.
– Install the shaft seal with a Seal Installer - Selector Shaft Oil
Seal - T10174- . Do not tilt the seal.
– Multifunction transmission range switch, installing and adjust‐
ing. Refer to
⇒ "2.2 Multifunction Transmission Range Switch F125 , Re‐
moving, Installing and Adjusting", page 123
8-Speed Automatic Transmission 0C8 - Edition 08.2017
.
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2. Selector Lever and Multifunction Transmission Range Switch F125
Audi Q7 2007 ➤
.
129