Selector Lever Transmission Range Position Display Unit Y26 , Removing And Installing; Protected By Copyright. Copying For Private Or Commercial Purposes, In Part Or In Whole, Is Not; Selector Lever Handle; Selector Lever Transmis- Sion Range Position Display Unit - Y26 - Audi Q7 2007 Repair Manual

3.4 Selector Lever Transmission Range Po‐
sition Display Unit - Y26- , Removing
and Installing
Removing
– Move the selector lever into "N".
– Remove the frame for the selector lever boot -A- -arrows-.
– Fold up the selector lever boot.

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not

permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Release the retaining spring -2- and remove the Selector Lev‐
er Transmission Range Position Display Unit - Y26- -1- in the
direction of -arrow-.
– Disconnect the connector.
Installing
Install in reverse order of removal.
3.5 Selector Lever Sensor System Control
Module - J587- with Tiptronic Switch -
F189- , Removing and Installing
Note
The Selector Lever Sensor System Control Module - J587-
♦
and the Tiptronic Switch - F189- are combined in one compo‐
nent.
The Tiptronic Switch - F189- magnets are secured in the cov‐
♦
er.
Removing
– Remove the handle from the selector lever. Refer to
⇒ "3.2 Selector Lever Handle, Removing and Installing", page
33 .
– Remove the Selector Lever Transmission Range Position Dis‐
play Unit - Y26- . Refer to
8-Speed Automatic Transmission 0C8 - Edition 08.2017
Audi Q7 2007 ➤
39

3. Selector Lever Handle