Atf, Draining - Audi Q7 2007 Repair Manual

8-speed automatic transmission 0c8
Hide thumbs Also See for Q7 2007:
Table of Contents

Advertisement

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
– Tighten the ATF check plug -1- with a new gasket, tightening
specification. Refer to
The ATF level test is now completed.
– Turn off the engine.
– Install the rear noise insulation. Refer to ⇒ Body Exterior; Rep.
Gr. 66 ; Underbody Trim Panels .
Tightening Specifications
Component
ATF check plug to ATF pan
8.3

ATF, Draining

Special tools and workshop equipment required
♦ Used Oil Collection And Extraction Unit - SMN372500-
♦ Protective eyewear
Procedure
Caution
♦ Do not start the engine or tow the vehicle if there is no ATF
in the transmission.
Conditions
Move the vehicle onto a 4-column shop hoist or over a work
pit so it is completely level.
Selector lever in "P".
The engine is off.
Note
Follow all disposal regulations for transmission fluids.
– Remove the rear noise insulation -2-. Refer to ⇒ Body Exte‐
rior; Rep. Gr. 66 ; Underbody Trim Panels .
WARNING
Wear protective eyewear.
90
Rep. Gr.37 - Controls, Housing
⇒ page 90
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Nm
16

Advertisement

Table of Contents
loading

Table of Contents