Audi Q7 2007 Repair Manual page 80

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
– Mount the -10-222A- on the notches on the longitudinal mem‐
ber and install the remaining parts of the -10-222A/19- as
illustrated.
– Slide the -T40091/2- with the -T40093/5- into both -T40093/4- .
WARNING
Risk of accident if the engine support bridge is not secure.
♦ Secure the -T40091/2- with the bolts and splints from the
-T40093/4- .
– Attach the carabiner hook from the -10-222A/10- to the front
lifting eye on the right side of the engine.
– Position the -VAG1383A- with the -T40173- under the trans‐
mission and secure it with a strap, as illustrated.
Caution
Danger of causing damage to the ATF pan.
♦ Adjust the transmission support so that the transmission
is not resting on the surface of the ATF pan.
– Remove the bolts -1 and 2- from the transmission support.
– Carefully lower the transmission with the -VAG1383A- .
– Pretension the engine evenly using the three spindles, but do
not lift.
Note
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Place a clean cloth under the separating point to catch the
♦
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
escaping ATF.
with respect to the correctness of information in this document. Copyright by AUDI AG.
Pay attention to the rules of cleanliness when working on an
♦
automatic transmission. Refer to
⇒ "8.3 Transmission, Clean Working Conditions", page 12
76
Rep. Gr.37 - Controls, Housing
.