Audi Q7 2007 Repair Manual page 66

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
– Remove the rear noise insulation -2-. Refer to ⇒ Body Exte‐
rior; Rep. Gr. 66 ; Underbody Trim Panels .
– Remove the bolts -arrows- and the noise insulation bracket.
Vehicles with a 3.0L TDI Engine
– Mark the hoses -arrows- for the Differential Pressure Sensor
- G505- to the pressure lines on the particulate filter with dif‐
ferent colors to prevent mixing them up when installing them
later.
– Pull the hoses -arrows- to the Differential Pressure Sensor -
G505- off the pressure lines on the particulate filter.
All Vehicles
– Remove the bolts -1, 3 and 4- from the selector lever cable
heat shield, if equipped.
Note
Ignore item -2-.
– Move the heat shield to the side.
62
Rep. Gr.37 - Controls, Housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.