Audi Q7 2007 Repair Manual page 129

– Place the -T10173- on the selector shaft.
– Turn the multifunction transmission range switch until the tab
on the connector -arrow 1- locks into the groove on the -
T10173- .
– Install the screw on the side of the -T10173- hand-tight. This
secures the -T10173- to the selector shaft.
– Tighten the bolts -arrows B- for the Multifunction Transmission
Range Switch - F125- in this position.
– Remove the -T10173- .
– Connect the connector to the Multifunction Transmission
Range Switch - F125- .
Note
The illustration shows the installation position with the transmis‐
sion removed.
– Slide on both seals -1-.
– Slide on the lock washer -2-.
– Tighten the nut -3-.
– Bend the hook on the lock washer -2- carefully toward the nut
using a screwdriver.
Note
If one hook breaks, then the lock washer must be replaced.
– Push the cover -4- onto the selector shaft.
– Install the cap nut -5-.
Caution
Danger of causing damage to the transmission selector lever.
♦ Do not bend the transmission selector lever when instal‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
ling the selector lever cable. Control it if necessary.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
8-Speed Automatic Transmission 0C8 - Edition 08.2017
2. Selector Lever and Multifunction Transmission Range Switch F125
Audi Q7 2007 ➤
125