Audi Q7 2007 Repair Manual page 41

Installing
• In order to install the selector lever handle, the locking button
must be pulled out all the way and secured either with a cable
tie -A- or with the assembly tool -B- supplied with a new handle.
If the locking button was not properly secured when the handle
was being removed and it falls back inside the handle, then it must
be pulled out again and secured:
– Tape an adhesive pad or two-sided tape -2- to the locking but‐
ton -1-.
Note
As an alternative, use a 15 mm suction cup.
♦
Remove the adhesive pad or the two-sided tape after the han‐
♦
dle has been installed. Make sure there is no adhesive left
over.
– Push on the adhesive surface using a tool -3- with a clean, flat
surface as illustrated and pull out the locking button -arrow-.
– Secure the pulled-out locking button with a cable tie -A- or an
assembly tool -B- as illustrated.
– Remove the adhesive pad or the two-sided tape -2- and clean
the locking button -1-.
– Move the selector lever into "N".
Note
Pull on the rod -4- to move the selector lever.
– Fold the selector lever boot -2- upward and over the selector
lever handle -3-.
– Turn the locking ring all the way in the direction of -arrow-. The
markings -a and b- no longer line up.
– Press the selector lever handle with the locking button on the
driver side completely onto the selector lever until it locks in.
8-Speed Automatic Transmission 0C8 - Edition 08.2017
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi Q7 2007 ➤
37
3. Selector Lever Handle