Audi Q7 2007 Repair Manual page 39

Installing
Note
In order to install the selector lever handle, the locking button
♦
must be pulled out all the way and secured either with a cable
tie -arrow- or with the assembly tool supplied with a new han‐
dle.
If the lock button was not secured, do not pull it out from the
♦
handle using mechanical aids. Position the compressed air
gun under the handle and press the locking button out with
compressed air.
– Install the shifter lever handle completely on the shifter lever.
The lock button faces toward the driver.
• The handle must lock into the selector lever ring groove.
– Remove cable tie or assembly aid, lock button mechanism
engages in vertical groove on selector lever.
– If necessary, press lock button back into selector lever handle.
– Clamp the handle -2- to the selector lever, using a new clamp
-arrow-. Use the -VAG1275- .
– Install the selector lever boot frame -1- in the center console.
3.2.2 Selector Lever Handle, Removing and
Installing, Vehicles from MY 2013
Special tools and workshop equipment required
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
♦ Trim Removal Wedge - 3409-
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ The cable ties or the assembly aid for the button on the handle.
The assembly aid is already installed at the factory when a
new handle is ordered.
Removing
– Pull the parking brake button to activate the electro-mechani‐
cal parking brake.
– Move the selector lever into "N".
8-Speed Automatic Transmission 0C8 - Edition 08.2017
Audi Q7 2007 ➤
35
3. Selector Lever Handle