Transmission Fluid Auxiliary Hydraulic Pump 2 V476 , Removing And Installing, Vehicles With Start/Stop System - Audi Q7 2007 Repair Manual

1.5 Transmission Fluid Auxiliary Hydraulic
Pump 2 - V476- , Removing and Instal‐
ling, Vehicles with Start/Stop System
Special tools and workshop equipment required
♦ Used Oil Collection And Extraction Unit - SMN372500-
Removing
Caution
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
♦ Do not start the engine or tow the vehicle if there is no ATF
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
in the engine or if the auxiliary hydraulic pump is removed.
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Drain the ATF. Refer to
– Place the -SMN372500- under the transmission.
– Disconnect the connector -A-.
– Remove the bolts -1- and the Transmission Fluid Auxiliary Hy‐
draulic Pump 2 - V476- .
Installing
Install in reverse order of removal. Note the following:
– Fill with ATF. Refer to
Tightening Specifications
Component
Transmission Fluid Auxiliary Hydraulic Pump 2
- V476-
8-Speed Automatic Transmission 0C8 - Edition 08.2017
⇒ "8.3 ATF, Draining", page 90
⇒ "8.4 Filling ATF", page 91
.
.
Tightening
Specifications
32 Nm
1. Oil Pan, Oil Screen and Valve Body
Audi Q7 2007 ➤
121