Torque Converter, Draining - Audi Q7 2007 Repair Manual

1 - Torque Converter
❑ Refer to
⇒ "1.2 Torque Convert‐
er, Draining",
page 15 .
❑ Refer to
⇒ "1.4 Torque Convert‐
er, Checking",
page 17 .
❑ Refer to
⇒ "1.5 Torque Convert‐
er, Installing",
page 17 .
❑ Check the installation
dimension for the torque
converter before instal‐
ling the transmission.
Refer to ⇒ page 18
2 - Bolt
❑ 85 Nm
❑ Replace
3 - Cover
❑ Version depending on
the engine installed.
❑ The covers prevent dust
and dirt from getting into
the torque converter bell
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
housing.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4 - Flange
❑ For the starter.
❑ 3.0L TFSI engine only
5 - Bolt
❑ 9 Nm
❑ 3.0L TFSI engine only
6 - Shaft Seal
❑ For the torque converter.
❑ Refer to ⇒ "1.3 Torque Converter Shaft Seal, Removing and Installing", page 16
1.2

Torque Converter, Draining

Special tools and workshop equipment required
♦ Used Oil Collection and Extraction Unit - SMN372500-
Procedure
If the ATF becomes dirty due to shavings or during a major trans‐
mission overhaul, then the torque converter must be drained as
follows:
8-Speed Automatic Transmission 0C8 - Edition 08.2017
.
Audi Q7 2007 ➤
.
15
1. Torque Converter