Crankshaft Seal, Removing And Installing, Transmission Side - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
6-Cylinder Direct Injection 3.0L 4V TFSI Supercharged Engine - Edition 01.2016
Special tools and workshop equipment required
♦ Gauge - Sender Wheel - T10473-
Procedure
• Sensor wheel removed. Refer to
moving and Installing", page 63
Caution
There is a risk of destroying the sensor wheel by magnetic
force.
♦ Do not place the sensor wheel near magnets (for example
lamp base, speakers).
♦ If the drive plate/flywheel or the sensor wheel itself is re‐
moved or replaced, the sensor wheel function must be
checked before installing.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Check the entire circumference of the sensor wheel with the
Gauge - Sender Wheel - T10473- as shown.
Sensor wheel test diagram
A - Sensor Wheel OK
B - Sensor Wheel Faulty
2.5 Crankshaft Seal, Removing and In‐
stalling, Transmission Side
Special tools and workshop equipment required
♦ Seal Installer - Crankshaft - T10122A-
♦ Seal Installer - Crankshaft - Guide Piece - T10122/6-
♦ Puller - Crankshaft/Power Steering Seal - T20143/2-
64
Rep. Gr.13 - Crankshaft, Cylinder Block
⇒ "2.3 Sensor Wheel, Re‐
.