Audi Q7 2007 Repair Manual page 81

– Remove the bolts -1, 2 and 3- and pull the ATF pipes off the
transmission.
Note
Depending on the date of manufacture, the ATF pre-heater and
the bolts -2- are not attached to the top of the transmission.
– Seal any open lines and connections with a clean plug from
the -VAS6122- .
– Separate the transmission from the engine by pushing the tor‐
que converter off the drive plate through opening for the starter
that was removed earlier.
Caution
A torque converter that slips out can destroy the ATF pump
driver if the -30-211A- is mounted.
When converter is inserted correctly, distance -a- between con‐
tact surfaces on threaded holes and on converter and torque
converter bell housing contact surfaces is at least 19 mm.
– Use the -30-211A- to secure the torque converter inside the
transmission from falling out.
– Secure the -3033- to the transmission and to the transfer case
as illustrated.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– If it is necessary to separate the transmission from the transfer
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
case, use the -VAS6100- to lift the transmission with the trans‐
fer case off the -VAG1383A- and set it down so it is not resting
on the oil pan.
– Separate the transfer case from the transmission. Refer to ⇒
Transfer Case 0BU, Front Final Drive 0BM, 0C1 and 0BN,
Rear Final Drive 0BP; Rep. Gr. 39 .
8-Speed Automatic Transmission 0C8 - Edition 08.2017
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi Q7 2007 ➤
6. Transmission, Removing and Installing
77