Shift Mechanism Function Unit, Removing And Installing - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
1 - Function Unit Housing
2 - Selector Lever Position
Locking Lever "P"
❑ Removing and instal‐
ling. Refer to
⇒ "4.5 Selector Lever P
Position Locking Lever,
Removing and Instal‐
ling", page 52 .
3 - Bushings
4 - Axial Bearing
❑ For the shift gate.
5 - Bearing Shell
❑ For the shift gate.
❑ Clipped to the function
unit housing.
6 - Locking Plate
❑ For the axial bearing.
❑ Replace
7 - Shift Bearing
❑ For the shift gate.
8 - Bearings
❑ For the shift bearing.
9 - Shift Gate
❑ Removing and instal‐
ling. Refer to
⇒ "4.4 Shift Gate, Re‐
moving and Installing",
page 48 .
10 - Shift Lock Solenoid -
N110-
❑ Removing and installing. Refer to
⇒ "4.6 Shift Lock Solenoid N110 , Removing and Installing", page 53
11 - Transmission Park Selector Switch - F305-
❑ Removing and installing. Refer to
⇒ "4.7 Transmission Park Selector Switch F305 , Removing and Installing", page 57
12 - Guide
❑ For the emergency release lever.
❑ Is clipped inside the function unit housing.
13 - Stop Buffer
4.2 Shift Mechanism Function Unit, Remov‐
ing and Installing
Special tools and workshop equipment required
♦ Socket and Key - T40031-
Removing
– Remove the handle from the selector lever. Refer to
⇒ "3.2 Selector Lever Handle, Removing and Installing", page
33 .
42
Rep. Gr.37 - Controls, Housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
.