Audi Q7 2007 Repair Manual page 28

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
– Get the control module identification and coding from the pre‐
vious Transmission Control Module - J217- .
– Turn off the ignition and remove the key.
– Remove the front passenger seat. Refer to ⇒ Body Interior;
Rep. Gr. 72 .
– Open the drawer -1- under the front passenger seat.
– Release the clips on the back of the cover -2- in the direction
of -arrow A-.
– Remove the cover from the front passenger seat in the direc‐
tion of -arrow B-.
– Remove the bolt -4-.
– Disconnect the connectors -1 and 2-.
– Remove the mount -3- with the control modules.
Caution
Risk of damaging transmission components.
♦ You must first discharge yourself of any static electricity
by touching a grounded metal object (bare handed) before
touching or removing the Transmission Control Module -
J217- .
♦ Never touch the connectors in the Transmission Control
Module - J217- . Static discharging can damage the Trans‐
mission Control Module - J217- .
– To discharge static, touch vehicle ground with hand (without
glove).
– Open the clips in the direction of -arrows- and remove the
Transmission Control Module - J217- -3- as far as the stop. If
necessary, release clips again and remove control module
from mount.
Installing
Install in reverse order of removal. Note the following:
– Install the front passenger seat. Refer to ⇒ Body Interior; Rep.
Gr. 72 .
• If the Transmission Control Module - J217- was replaced:
– Perform a transmission adaptation. Refer to
⇒ "8.4 Transmission Adaptation", page 12
24
Rep. Gr.37 - Controls, Housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.