Audi Q7 2007 Repair Manual page 107

– Remove the bolt -1- and pull the ATF pipes out of the thermo‐
stat -2-.
– Seal off the ATF pipes and thermostat with clean plugs.
– Remove the ATF pipes from/to ATF cooler on the thermostat
-2-. Counterhold at the thermostat.
– Seal off the ATF pipes and thermostat with clean plugs.
– Loosen the clips -arrow- from the condenser -1- and ATF cool‐
er -2-.
– Remove the ATF cooler and pipes.
– Remove the ATF pipes from the ATF cooler. Counterhold the
ATF cooler at the same time.
– Seal off the ATF pipes and the ATF cooler with clean plugs.
– Remove the screw on the ATF pipe bracket to the right side of
the engine.
Note
Place a clean cloth under the separating point to catch the
♦
escaping ATF.
Pay attention to the rules of cleanliness when working on an
♦
automatic transmission. Refer to
⇒ "8.3 Transmission, Clean Working Conditions", page 12
8-Speed Automatic Transmission 0C8 - Edition 08.2017
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi Q7 2007 ➤
103
9. ATF Circuit