Filling Atf - Audi Q7 2007 Repair Manual

– Place the -SMN372500- under the transmission.
– Remove the drain plug -1- from the ATF pan.
– Drain the ATF.
Note
The overflow tube -C- is screwed into the opening in the plug.
– Remove the overflow pipe -C -.
– Allow excess ATF to drain out.
– Install the overflow pipe -C-. For the correct tightening speci‐
fication. Refer to ⇒ page 91
Note
Overflow pipes with different lengths with different lengths are in‐
stalled. For the correct allocation. Refer to the Parts Catalog.
– Remove the ATF pan and let any remaining ATF drain out.
Refer to
⇒ "1.1 ATF Pan, Removing and Installing", page 117
Note
It is necessary to remove the ATF pan from the transmission
♦
in order to change the ATF. This means approximately 6 liters
(6.3 qts) of ATF will be changed.
Only approximately 3.5 liters (3.7 quarts) of ATF will drain out
♦
if the ATF is drained via the removed overflow pipe -C- only.
– Clean and install the ATF pan. Refer to
⇒ "1.1 ATF Pan, Removing and Installing", page 117
– Fill with ATF. Refer to
Tightening Specifications
Component
Overflow pipe in the opening for the plug
8.4

Filling ATF

Special tools and workshop equipment required
♦ Used Oil Collection And Extraction Unit - SMN372500-
♦ Oil Filler - VAS6262A-
♦ If necessary, adapter for oil filling Oil Filler - Adapter 6 -
VAS6262/6-
8-Speed Automatic Transmission 0C8 - Edition 08.2017
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
⇒ "8.4 Filling ATF", page 91
.
.
.
Nm
1
8. ATF Level Inside Transmission
Audi Q7 2007 ➤
91