Audi Q7 2007 Repair Manual page 26

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
Transmission Range Display - Y6-
Installed location: Integrated inside the instrument cluster
Note
The Transmission Range Display - Y6- can only be replaced to‐
gether with the instrument cluster.
Instrument cluster, removing and installing. Refer to ⇒ Electrical
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Equipment; Rep. Gr. 90 ; Instrument Cluster .
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Multifunction Transmission Range Switch - F125-
Component location: On selector shaft at outer right of transmis‐
sion.
Note
Always check the connectors on the Multifunction Transmission
Range Switch - F125- before replacing it. Refer to
⇒ "2.2 Multifunction Transmission Range Switch F125 , Remov‐
ing, Installing and Adjusting", page 123
Refer to
⇒ "2.2 Multifunction Transmission Range Switch F125 , Remov‐
ing, Installing and Adjusting", page 123
Transmission Input Speed Sensor - G182-
The Transmission Input Speed Sensor - G182- is installed near
the ATF pump in the transmission.
Currently the transmission must be replaced to replace the Trans‐
mission Input Speed Sensor - G182- .
Transmission Output Speed Sensor - G195-
The Transmission Output Speed Sensor - G195- is installed un‐
der the valve body.
Removing and installing the Transmission Output Speed Sensor
- G195- . Refer to
⇒ "1.4 Transmission Output Speed Sensor G195 , Removing and
Installing", page 120 .
22
Rep. Gr.37 - Controls, Housing
.
.