Audi Q7 2007 Repair Manual page 86

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
– Turn the crankshaft 120° in direction of engine rotation and
install the torque converter bolts through the opening for the
starter and tighten them hand-tight. Refer to
⇒ "1 Torque Converter", page 14
– After installing an exchanged transmission or after repairing
transmission. Refer to
⇒ "9.5 ATF Pipes and ATF Cooler, Cleaning", page 107
– Install the selector lever cable and check the adjustment. Re‐
fer to
⇒ "5.2 Selector Lever Cable, Removing and Installing",
page 61 .
– ATF level, checking and filling. Refer to
⇒ "8.2 ATF Level, Checking and Filling", page 84
– Tightening specifications. Refer to
• If the transmission was replaced:
– Perform a transmission adaptation. Refer to
⇒ "8.4 Transmission Adaptation", page 12
82
Rep. Gr.37 - Controls, Housing
.
⇒ page 78 .
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.