Audi Q7 2007 Repair Manual page 128

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
– Remove the cap nut -5-.
– Remove cover -4- from the selector shaft.
– Carefully bend back the hooks on the lock washer -2- using a
screwdriver.
Note
If one hook breaks, then the lock washer must be replaced.
– Remove the nut -3-, lock washer -2- and seals -1- from the
selector shaft.
– Disconnect the connector from the Multifunction Transmission
Range Switch - F125- .
– Remove the bolts -arrows B- and then remove the multifunc‐
tion transmission range switch -arrow A- from the selector
shaft.
Installing and Adjusting
Tightening Specifications
• Refer to
⇒ "2 Selector Lever and Multifunction Transmission Range
Switch F125 ", page 122
• Refer to
⇒ Fig. ""Selector Lever Cable Heat Shield - Tightening Spec‐
ification"" , page 61
– Move the selector lever into "N".
– Remove the selector lever cable heat shield bolts
-1, 3 and 4-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Note
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Ignore item -2-.
– Move the heat shield to the side.
– Remove ball head -1- on the selector lever cable from the se‐
lector shaft lever using the -80-200- .
Note
Ignore item -2-.
– Move the selector lever on the transmission into "N".
– Install the Multifunction Transmission Range Switch - F125-
onto the selector shaft.
– Install the bolts for the Multifunction Transmission Range
Switch - F125- all the way by hand.
124
Rep. Gr.38 - Gears, Hydraulic Controls
.
.