Selector Lever Cable; Overview - Selector Lever Cable - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
5

Selector Lever Cable

⇒ "5.1 Overview - Selector Lever Cable", page 60
⇒ "5.2 Selector Lever Cable, Removing and Installing",
page 61
⇒ "5.3 Selector Lever Cable, Adjusting", page 64
5.1

Overview - Selector Lever Cable

1 - Selector Lever Cable
❑ Do not bend.
❑ Removing and instal‐
ling. Refer to
⇒ "5.2 Selector Lever
Cable, Removing and
Installing", page 61
❑ The selector lever cable
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability must be replaced if the
with respect to the correctness of information in this document. Copyright by AUDI AG.
rubber grommet is dam‐
aged.
❑ Ball socket and ball
head must be free of oil
and grease.
❑ Make sure the rubber
grommet for the selector
lever cable is installed
correctly in the selector
mechanism.
❑ Adjusting, Refer to
⇒ "5.3 Selector Lever
Cable, Adjusting",
page 64 .
2 - Clip
❑ For the selector lever
cable on the selector
mechanism function
unit.
❑ Replace
3 - Bolt
❑ 13 Nm
❑ For adjusting the selec‐
tor lever cable.
4 - Bolt
❑ For selector lever cable.
❑ The plastic retaining spring on adjustment slide must lock the pins so that they cannot fall out.
5 - Adjustment Slide
6 - Selector Lever
❑ Ball socket and ball head must be free of oil and grease.
❑ Removing and installing. Refer to
7 - Cable Mounting Bracket
❑ For selector lever cable.
8 - Bolt
❑ M6: 9 Nm
❑ M8: 22 Nm
60
Rep. Gr.37 - Controls, Housing
.
⇒ "2.3 Selector Lever, Removing and Installing", page 126 .