Selector Lever Boot, Removing From Selector Lever Handle; Selector Lever Boot, Removing From Selector Lever Han- Dle; Refer To ⇒ "3.3 Selector Lever Boot, Removing From Selector Lever Handle - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
– Turn the locking ring all the way in the direction of -arrow- until
it locks and the markings -a and b- line up.
Caution
Danger of causing damage to the selector lever handle.
♦ The locking ring can be turned only when the handle is
installed completely.
– Remove cable ties or assembly tools. The locking button
mechanism will engage in the vertical groove on the selector
lever. If necessary, press the locking button into the selector
lever handle.
– Move the button mechanism through "R" and "S" to perform
the function test.
• If the selector lever positions cannot be reached, remove the
handle again.
– Pull the selector lever boot downward and attach it to the Mul‐
timedia System Control Head - E380- .
3.3 Selector Lever Boot, Removing from
Selector Lever Handle
⇒ "3.3.1 Selector Lever Boot, Separating from Selector Lever
Handle, Vehicles through MY 2012", page 38
3.3.1 Selector Lever Boot, Separating from
Selector Lever Handle, Vehicles
through MY 2012
Removing
– Remove the handle from the selector lever. Refer to
⇒ "3.2 Selector Lever Handle, Removing and Installing", page
33 .
– Bind together the spring tabs -A- on the selector lever handle
using a cable tie -B- as illustrated.
– Slide the sleeve for the selector lever boot -C- over the tabs in
the direction of -arrow-.
– Remove the cable tie and remove the both the sleeve and se‐
lector lever boot from the selector lever.
Installing
Install in reverse order of removal. At the same time note the fol‐
lowing:
Selector lever boot installed position
• The longer side of the selector lever boot frame faces toward
the driver side (toward the Selector Lever Transmission
Range Position Display Unit - Y26- ).
– Install the handle on the selector lever. Refer to
⇒ "3.2 Selector Lever Handle, Removing and Installing", page
33 .
38
Rep. Gr.37 - Controls, Housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.