Audi Q7 2007 Repair Manual page 101

9.1.2 Overview - ATF Lines, ATF Cooler and ATF Pre-Heater, Vehicles with 6-
Cylinder 3.0L TDI Engine
1 - Bolt
❑ 20 Nm
2 - ATF Pre-Heater
❑ Installed depending on
the version
❑ Removing and instal‐
ling. Refer to
⇒ "9.2 ATF Preheater,
Removing and Instal‐
ling", page 99
❑ The Cooling Oil Valve -
N471- is installed in
front of the ATF pre-
heater. Refer to
⇒ Fig. "" Cooling Oil
Valve -N471- "" ,
page 23 .
3 - Bolt
❑ 8 Nm
4 - ATF Pipes
5 - Bolt
❑ 8 Nm
❑ Insert the pipe all the
way by hand before
tightening.
6 - Bolt
❑ 8 Nm
7 - Clip
❑ Make sure it fits secure‐
ly.
8 - ATF Cooler
❑ Removing and instal‐
ling. Refer to ⇒ "9.3 ATF Pipes and ATF Cooler, Removing and Installing", page 102
9 - O-Rings
❑ Replace
❑ Coat with ATF.
10 - Clamping Pins
❑ For the ATF pipes.
❑ Depending on the date of manufacture with union nut. Refer to
⇒ Fig. ""Mounting ATF Pipes to the ATF Cooler"" , page 98
11 - Bolts
❑ Depending on the date of manufacture.
❑ Tightening specification. Refer to
12 - ATF Pipes
❑ Depending on the date of manufacture with union nut. Refer to
⇒ Fig. ""Mounting ATF Pipes to the ATF Cooler"" , page 98
13 - Union Nuts
❑ Depending on the date of manufacture.
8-Speed Automatic Transmission 0C8 - Edition 08.2017
⇒ Fig. ""Mounting ATF Pipes to the ATF Cooler"" , page 98
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi Q7 2007 ➤
.
.
.
.
97
9. ATF Circuit