Audi Q7 2007 Repair Manual page 67

– Remove ball head -1- on the selector lever cable from the se‐
lector shaft lever using the -80-200- .
– Remove the clips -3- and the selector lever cable from the
transmission.
Note
Do not bend or kink the selector lever cable.
♦
Ignore item -2-.
♦
Installing
Install in reverse order of removal. Note the following:
Tightening Specifications
• Refer to ⇒ "5 Selector Lever Cable", page 60
• Refer to
⇒ Fig. ""Selector Lever Cable Heat Shield - Tightening Spec‐
ification"" , page 61
Note
Secure all hose connections with hose clamps of the same type
as those equipped by the factory. Refer to the Parts Catalog.
– Secure selector lever cable to cable that was guided in during
removal.
– Guide the selector lever cable and rubber grommet -2- into the
selector mechanism function unit -1-.
Caution
Danger of causing damage to the transmission selector lever.
♦ Do not bend the transmission selector lever when instal‐
ling the selector lever cable. Control it if necessary.
– Press the selector lever cable -1- carefully onto the selector
lever.
– Secure the grommet selector lever cable grommet to the cable
bracket with a new clip -3-.
8-Speed Automatic Transmission 0C8 - Edition 08.2017
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
Audi Q7 2007 ➤
63
5. Selector Lever Cable