Audi Q7 2007 Repair Manual page 32

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
selector lever. The selector lever can be moved into a another
gear.
• For speeds below 2 km/h (almost standstill) and shifting into
selector lever position "N", the shift lock solenoid must only
engage after approximately 1 second. The selector lever can
be move out of "N" only when the brake pedal is pressed.
Selector Lever in "P" and the Ignition Turned On:
– Do not press the brake pedal.
• The selector lever is locked and cannot be moved out of "P"
while locking button on selector lever handle is pressed. The
Shift Lock Solenoid - N110- locks the selector lever.
– Press the brake pedal and hold it down.
• The Shift Lock Solenoid - N110- unlocks the selector lever. It
is possible to shift into a gear. Press the locking button in the
selector lever handle and slowly move the selector lever out
of "P" through "R, N, D, S". While doing this, make sure the
Transmission Range Display - Y6- inside the instrument clus‐
ter matches the actual position of the selector lever.
The Selector Lever Is in "N" and the Ignition is Turned On:
– Do not press the brake pedal.
• After a brief moment: The selector lever is locked and cannot
be moved out of "N" even though the locking button in the se‐
lector lever handle is pressed. The Shift Lock Solenoid - N110-
locks the selector lever.
– Press the brake pedal.
• The Shift Lock Solenoid - N110- unlocks the selector lever. It
is possible to shift into "D".
Selector Lever in "D" and the Ignition is On:
– Move the selector lever into the "tiptronic gate".
• The "D" in the Selector Lever Transmission Range Position
Display Unit - Y26- must turn off and the "+" and "–" must turn
on.
• The Transmission Range Display - Y6- in the instrument clus‐
ter must change from "D1" to "M1" when the selector lever is
moved into the "tiptronic gate".
Note
"M1" for manual Tiptronic, 1st gear.
If the specified values are not obtained:
– Locking button on selector lever handle, checking. Refer to
⇒ page 29 .
– Refer to ⇒ "5.3 Selector Lever Cable, Adjusting", page 64
– Check the ignition key lock. Refer to
2. Ignition Key Lock, Checking
– Turn the key to the right to the "ignition on" position.
– Press the brake pedal and hold it down.
• It must be possible to move the selector lever out of "P" without
"getting stuck" when the locking button in the selector lever
handle is pressed.
28
Rep. Gr.37 - Controls, Housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 28 .
.