Selector Lever Cable, Removing And Installing - Audi Q7 2007 Repair Manual

❑ For attaching the cable bracket to the transmission.
Size depends on the version.
9 - Clip
❑ For attaching the selector lever cable to the cable bracket.
❑ Always replace.
10 - Bolt
❑ M6: 9 Nm
❑ M8: 22 Nm
❑ For attaching the cable bracket to the transmission.
Size depends on the version.
Selector Lever Cable Heat Shield - Tightening Specification
– Tighten the bolts -1 through 4- to 9 Nm.
5.2 Selector Lever Cable, Removing and In‐
stalling
Special tools and workshop equipment required
♦ Pry Lever - 80-200-
Removing
Note
Before removing selector lever cable, secure a cable on selector
lever cable so that it can be threaded easily when installing.
– Shifter mechanism function unit, removing. Refer to
⇒ "4.2 Shift Mechanism Function Unit, Removing and Instal‐
ling", page 42 .
– Push the rubber grommet -arrow- forward and out of the se‐
lector mechanism function unit lower section.
8-Speed Automatic Transmission 0C8 - Edition 08.2017
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi Q7 2007 ➤
61
5. Selector Lever Cable