Selector Lever, Removing And Installing - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
– Press the selector lever cable -1- carefully onto the selector
lever.
– Turn on the ignition.
– Connect the -Vehicle Diagnostic Tester- and select the follow‐
ing menu item:
♦
On-Board Diagnostics (OBD)
♦
02 - Transmission Electronics
♦
Measured Values
♦
Driving Gear
– Move the selector lever slowly from "P" through "R, N, D and
S".
• The engage gear on the selector lever must light up in the
Selector Lever Transmission Range Position Display Unit -
Y26- .
• The Transmission Range Display - Y6- in the instrument clus‐
ter, on the Selector Lever Transmission Range Position Dis‐
play Unit - Y26- and the display on the -Vehicle Diagnostic
Tester- must match the selector lever position.
If the conditions are not met:
– Repeat adjusting the Multifunction Transmission Range
Switch - F125- and adjust the selector lever cable, if neces‐
sary. Refer to
⇒ "5.3 Selector Lever Cable, Adjusting", page 64
If the conditions are met:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Install in reverse order of removal. Note the following:
– Check selector lever cable adjustment. Refer to
⇒ "5.3 Selector Lever Cable, Adjusting", page 64
– Install the ATF pipes. Refer to
– ATF level, checking and filling. Refer to
⇒ "8.2 ATF Level, Checking and Filling", page 84
– Check the ATF pipe connections for leaks while checking the
ATF level.
2.3

Selector Lever, Removing and Installing

Special tools and workshop equipment required
♦ Pry Lever - 80-200-
126
Rep. Gr.38 - Gears, Hydraulic Controls
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ "9 ATF Circuit", page 94
.
.
.
.