Gearshift Mechanism, Checking - Audi Q7 2007 Repair Manual

9 - Bolt
❑ 1 Nm
❑ Quantity: 4
10 - Selector Lever Sensor System Control Module - J587- with Tiptronic Switch - F189-
❑ Removing and installing. Refer to
⇒ "3.5 Selector Lever Sensor System Control Module J587 with Tiptronic Switch F189 , Removing and
Installing", page 39
11 - Shift Lock Solenoid - N110-
❑ Removing and installing. Refer to
⇒ "4.6 Shift Lock Solenoid N110 , Removing and Installing", page 53
❑ Refer to ⇒ "2.3 Selector Mechanism, Performing Emergency Release", page 29
12 - Selector Mechanism Function Unit
❑ Checking, Refer to
❑ Removing and installing. Refer to
⇒ "4.2 Shift Mechanism Function Unit, Removing and Installing", page 42
❑ Refer to ⇒ "4 Selector Mechanism Function Unit", page 41
❑ With Transmission Park Selector Switch - F305-
❑ Removing and installing. Refer to
⇒ "4.7 Transmission Park Selector Switch F305 , Removing and Installing", page 57
13 - Threaded Pin
❑ 6.5 Nm
❑ Quantity: 4
❑ For the selector mechanism function unit to the lower section.
14 - Bolt
❑ 6.4 Nm
❑ Quantity: 2
❑ For the centering bracket to the lower section of the selector mechanism function unit.
15 - Bolt
❑ 10 Nm
❑ Quantity: 4
❑ For the lower section of the selector mechanism function unit to the body.
16 - Selector Mechanism Function Unit Lower Section
❑ Removing and installing. Refer to
⇒ "4.3 Selector Mechanism Function Unit Lower Section, Removing and Installing", page 46
17 - Centering Bracket
❑ May not be installed again if it is damaged or removed; necessary for factory production only.
2.2

Gearshift Mechanism, Checking

Overview:
♦ 1. Selector mechanism function. Refer to
♦ 2. Check the ignition key lock. Refer to
♦ 3. Selector lever handle locking button, checking. Refer to
⇒ page 29 .
1. Selector Mechanism Functionality Test
• The starter does not work when the selector lever is in "S", "D",
"R" or in the "tiptronic gate".
• If selector lever position "N" is selected at speeds greater than
5 km/h, the shift lock solenoid must not engage and block the
8-Speed Automatic Transmission 0C8 - Edition 08.2017
.
⇒ "2.2 Gearshift Mechanism, Checking", page 27
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 27
⇒ page 28
.
.
.
.
.
Audi Q7 2007 ➤
.
.
.
.
2. Selector Mechanism
27