Audi Q7 2007 Repair Manual page 54

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
– Pry off the retaining pins -A- with a screwdriver.
– Remove the micro-switch -B-.
Note
Two micro-switches make up the Transmission Park Selector
Switch - F305- . Micro-switch -B- is one of the two. The two micro-
switches create the signal that the electronic ignition key removal
lock needs to release the key only when the selector lever is in P.
– Disengage the wiring from the tab -arrow C- and remove the
micro-switch from the selector mechanism.
– Remove the shift gate -1- downward.
Installing
Install in reverse order of removal. Note the following:
Note
Coat the bearings and the sliding surfaces with Polycarbamide
Grease - G 052 142 A2- .
– Make sure the stop buffer fits correctly -1-.
Note
The stop buffer -1- is located on the opposite side on a RHD ve‐
hicle.
– Guide the shift gate -1- from underneath.
• Shift gate selector lever in "S" (as illustrated).
– Install the micro-switch -B- into the shift gate and secure it with
the retaining pin -A-.
Note
The micro-switch must be flush on all sides.
– Engage the wiring into the tab -arrow C-.
– Install both axial bearings -2- on the shift gate -1-.
– Place both shift bearings -3- on the shift gate.
50
Rep. Gr.37 - Controls, Housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.