Atf Preheater, Removing And Installing - Audi Q7 2007 Repair Manual

8-speed automatic transmission 0c8
Hide thumbs Also See for Q7 2007:
Table of Contents

Advertisement

Pronged Ring on the ATF Pipe
Note
The upper ATF pipe -3- has a pronged ring -1- to protect it from
touching the longitudinal member -4-.
If the pronged ring is not there and the ATF pipe is damaged,
then the ATF pipe must be replaced.
– Check the ATF pipes for damage and replace them if neces‐
sary.
– Install the pronged ring -1- around the upper ATF pipe -3- just
behind the thermostat -2-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Slide the pronged ring -1- on the ATF toward the ATF cooler
with respect to the correctness of information in this document. Copyright by AUDI AG.
until it reaches the illustrated position.
9.2

ATF Preheater, Removing and Installing

Special tools and workshop equipment required
♦ Hose Clamps - Up To 40mm - 3093-
♦ Hose Clamps - Up To 25mm - 3094-
♦ Hose Clip Pliers - VAS6362-
♦ Used Oil Collection And Extraction Unit - SMN372500-
♦ Protective eyewear
Removing
– Remove the transfer case. Refer to ⇒ Transfer Case and Final
Drive; Rep. Gr. 34 ; Transfer Case .
– If present, remove heat shield -1- for the coolant lines from the
transmission. Remove the bolts -arrows A-.
– Remove the vacuum hose -1- from the vacuum pipe -2- (lead‐
ing to the brake booster).
– Place the -SMN372500- under the engine/transmission.
8-Speed Automatic Transmission 0C8 - Edition 08.2017
Audi Q7 2007 ➤
99
9. ATF Circuit

Advertisement

Table of Contents
loading

Table of Contents