Audi Q7 2007 Repair Manual page 91

ATF Level, Checking and Correcting
Note
The ATF level is checked at the ATF check hole.
♦
The ATF level is correct if a small amount of fluid drips out of
♦
the check hole (this is normal because the fluid expands as it
heats up) between 35 ° and 45 °C (95 ° and 113 °F) (for hot
countries 50 °C (122 °F)).
– Drive the vehicle onto a 4-column hoist or over a service pit so
that it is absolutely level.
– Remove the rear noise insulation -2-. Refer to ⇒ Body Exte‐
rior; Rep. Gr. 66 ; Underbody Trim Panels .
– Start the engine and let it run at idle.
– With engine idling depress the brake pedal and shift the se‐
lector lever through all the selector lever positions leaving the
selector lever at least 10 seconds in each position.
– Place the Used Oil Collection And Extraction Unit -
SMN372500- under the transmission.
Test Temperature 35 ° to 45 °C (95 ° to 113 °F)
– Remove the plug -1- in the ATF pan for checking the ATF level.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
8-Speed Automatic Transmission 0C8 - Edition 08.2017
Audi Q7 2007 ➤
8. ATF Level Inside Transmission
87