Audi Q7 2007 Repair Manual page 51

– Push the rubber grommet -arrow- forward and out of the se‐
lector mechanism function unit lower section.
– Remove the hooks -1 and 2-.
– Remove the bolts -arrows-.
– Pull the lower section -1- of the selector mechanism function
unit slightly toward the rear and remove the bolts -arrows- from
the centering bracket -2-.
– Remove the selector mechanism function unit lower section.
– Remove center bracket upward. It may not be installed again.
Note
The center bracket is only needed for factory production.
Installing
Install in reverse order of removal. Note the following:
• Tightening specifications. Refer to
⇒ "2 Selector Mechanism", page 26
– Make sure the seal fits correctly on the selector mechanism
function unit lower section.
– Install the rubber grommet -arrow- on the selector lever cable
in the selector mechanism function unit lower section.
– Shifter mechanism function unit, installing. Refer to
⇒ "4.2 Shift Mechanism Function Unit, Removing and Instal‐
ling", page 42 .
8-Speed Automatic Transmission 0C8 - Edition 08.2017
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
Audi Q7 2007 ➤
4. Selector Mechanism Function Unit
47