Audi Q7 2007 Repair Manual page 62

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
♦ Test program
F305 - Transmission Park Selector
Switch
2. An electrical test on the micro-switch is also possible. If a con‐
tinuity test is performed with a multimeter, note that in this case,
there is a resistance value of approximately 470 Ohm when both
switches are closed.
Removing
– Shifter mechanism function unit, removing. Refer to
⇒ "4.2 Shift Mechanism Function Unit, Removing and Instal‐
ling", page 42 .
– Remove the shift gate. Refer to
⇒ "4.4 Shift Gate, Removing and Installing", page 48
– Pry off the retaining pins -A- in the direction of -arrow- with a
screwdriver.
– Remove the first micro-switch -B-.
– Disengage the wiring from the tab -arrow C- and remove the
micro-switch from the selector mechanism.
– Release the connector -D- and disconnect it from the Shift
Lock Solenoid - N110- .
– Release the connector -E- and disconnect is upward.
– Press the tab -C- in the direction of -arrow 1-.
– Remove the second micro-switch -B- in the direction of
-arrow 2-.
– Disengage the wire on the selector mechanism -arrows A-.
Installing
Note
Coat the bearings and the sliding surfaces with Polycarbamide
Grease - G 052 142 A2- .
– Guide micro-switch on longer electrical line into opening under
parking lock button in selector mechanism.
– Guide the shift gate -1- from underneath.
• Shift gate selector lever in "S" (as illustrated).
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
58
Rep. Gr.37 - Controls, Housing
.