Audi Q7 2007 Repair Manual page 102

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
❑ Tightening specification. Refer to
14 - O-Rings
❑ Replace
❑ Coat with ATF.
15 - Thermostat
16 - O-Rings
❑ Replace
❑ Coat with ATF.
17 - O-Rings
❑ Replace
❑ Coat with ATF.
18 - Bolt
❑ 8 Nm
19 - Bolt
❑ 8 Nm
❑ Insert the pipe all the way by hand before tightening.
20 - Bolt
❑ 25 Nm
❑ Insert the pipe all the way by hand before tightening.
21 - ATF Pipe
22 - Bolt
❑ 8 Nm
❑ Insert the pipe all the way by hand before tightening.
23 - O-Ring
❑ Replace
❑ Coat with ATF.
Mounting ATF Pipes to the ATF Cooler
I - Mounting with Clamping Joint
– Replace the O-rings and coat them with ATF.
– Insert the ATF pipe all the way into the ATF cooler by hand
and then tighten it.
– Tighten the bolts -1- to 10 Nm.
II - Mounting with Threaded Connection
– Replace the O-rings and coat them with ATF.
– Insert the ATF pipe all the way into the ATF cooler by hand
and then tighten it.
– Tighten the union nuts -2- to 20 Nm.
98
Rep. Gr.37 - Controls, Housing
⇒ Fig. ""Mounting ATF Pipes to the ATF Cooler"" , page 98
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.