Transmission, Installing, Vehicles With 6-Cylinder Engines - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
6.3 Transmission, Installing, Vehicles with
6-Cylinder Engines
Special tools and workshop equipment required
♦ Depth Gauge - VAS6082-
Installing
Install in reverse order of removal. Note the following:
Note
Replace bolts that are tightened to the specification.
♦
Replace self-locking nuts and bolts and seals, gaskets and O-
♦
rings.
The hose connections as well as the air guide pipes and hoses
♦
must be free of oil and grease before installing.
Secure all hose connections with hose clamps of the same
♦
type as those equipped by the factory. Refer to the Parts Cat‐
alog.
To secure the air guide hoses on their connections, spray the
♦
clamps used previously with rust remover before installing.
When installing, bring all cable ties back to same positions.
♦
Vehicles with a 3.0L TFSI Engine
– If the transmission was replaced: Install the starter flange -2-
on the new transmission.
– Attach the alignment sleeve -1- and the starter flange -2- with
the bolt -3- to the transmission, tightening specification
-Item 5- ⇒ Item 5 (page 15)
– Install the cover -4- for the starter.
All Vehicles
Tightening Specifications
Note
The tightening specifications apply only to lightly greased,
♦
oiled, phosphated or blackened nuts and bolts.
Additional lubricant such as engine or transmission oil may be
♦
used, but do not use graphite lubricant.
Do not use any ungreased parts.
♦
Tightening specification tolerance ± 15%.
♦
Component
Bolts/nuts
78
Rep. Gr.37 - Controls, Housing
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Tightening
Specifications
M6 9 Nm
M8 20 Nm
M10 40 Nm
M12 65 Nm