Audi Q7 2007 Repair Manual page 17

♦ After certain engine repairs such as replacing the mass airflow
sensor.
– Follow all information, procedures and requirements given in
"Guided Functions" exactly.
– -Vehicle Diagnostic Tester- is connected, then select and per‐
form
02 - Transmission Electronics 0C8 I J217
then
J217 - Transmission Control Module, Adaptation
Drive (Repair Group 38)
Note
After erasing the adaptation values, perform an adaptation drive
using "Guided Functions or Fault Finding". If the adaptation drive
cannot be performed for various reason, complete an extensive
test drive. Be sure to keep to the adaptation conditions as much
as possible.
General Adaptation Conditions
The adaptation can only take place when the appropriate defined
adaptation conditions are met.
The following information provides an overview of the criteria that
must be met during an adaptation:
♦ The ATF must be within a certain temperature range.
♦ A certain gear or selector lever position must be engaged.
♦ The engine load must be within a certain range. Generally a
very low engine load or very light pressure on the accelerator
pedal is required.
♦ There must be no Diagnostic Trouble Code (DTC) entries in
the transmission control module.
♦ Certain vehicle conditions must be present such as accelera‐
tion or deceleration, constant driving, vehicle stopped with the
engine running at idle, etc.
♦ There must be good road conditions, optimum road surface,
no steep inclines or declines and the road must be as level as
possible.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
8-Speed Automatic Transmission 0C8 - Edition 08.2017
using
Guided Functions
and
.
Audi Q7 2007 ➤
13
8. Repair Information