Audi Q7 2007 Repair Manual page 75

– Mount the -10-222A- on the fender bolting edge as illustrated.
• The -3033- spindles are in the back.
– Engage the spindle carabiner hook into the rear engine lifting
eyes.
– Mount the -10-222A- on the notches on the longitudinal mem‐
ber and install the remaining parts of the -10-222A/19- as
illustrated.
– Slide the -T40091/2- with the -T40093/5- into both -T40093/4- .
WARNING
Risk of accident if the engine support bridge is not secure.
♦ Secure the -T40091/2- with the bolts and splints from the
-T40093/4- .
– Attach the carabiner hook from the -10-222A/10- to the front
lifting eye on the right side of the engine.
– Pretension the engine evenly using the three spindles, but do
not lift.
– Position the -VAG1383A- with the -T40173- under the trans‐
mission and secure it with a strap, as illustrated.
Caution
Danger of causing damage to the ATF pan.
♦ Adjust the transmission support so that the transmission
is not resting on the surface of the ATF pan.
– Remove the bolts -1 and 2- from the transmission support.
– Separate the transmission from the engine by pushing the tor‐
que converter off the drive plate through opening for the starter
that was removed earlier.
– Carefully lower the transmission with the -VAG1383A- .
Caution
A torque converter that slips out can destroy the ATF pump
driver if the -30-211A- is mounted.
8-Speed Automatic Transmission 0C8 - Edition 08.2017
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi Q7 2007 ➤
6. Transmission, Removing and Installing
71