Valve Body, Removing And Installing - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
8-Speed Automatic Transmission 0C8 - Edition 08.2017
– Remove the bolts -arrows-.
– Remove the oil screen.
– Remove the oil strainer sealing ring from its seat in the valve
body.
Installing
Caution
Danger of causing damage to the seal.
♦ First install the oil screen so that it is loose. The oil strainer
centers itself noticeably in the valve body seat.
– Coat new sealing ring -1- with ATF and mount it on the suction
collar.
– Install the oil screen loosely on the valve body but do not push
it in yet.
– Turn the bolts -arrows- into the valve body approximately 3
turns, but not more.
– Center oil screen and press the oil screen evenly on the cor‐
ners all the way into the valve body and hold it in this position.
– Install the bolts all the way in by hand but do not tighten them.
Install in reverse order of removal. Note the following:
– Install the ATF pan. Refer to
⇒ "1.1 ATF Pan, Removing and Installing", page 117
– Fill with ATF. Refer to
Tightening Specification
Component
Oil screen to transmission
1.3

Valve Body, Removing and Installing

Removing
– Remove the ATF pan. Refer to
⇒ "1.1 ATF Pan, Removing and Installing", page 117
– Remove the ATF strainer. Refer to
⇒ "1.2 Oil Screen, Removing and Installing", page 117
118
Rep. Gr.38 - Gears, Hydraulic Controls
⇒ "8.4 Filling ATF", page 91
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
.
Nm
10
.
.