Audi Q7 2007 Repair Manual page 55

– Slide the shift gate into the function unit housing. If necessary,
push the emergency release lever -arrow- down to make it
possible to install the shift gate.
– Push the lower bearings -1- in on both sides.
• Bearings -1- must engage in the shift bearing bushings
-arrow- -A-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Press the new locking plate -2- onto rear axial bearing.
• Installed position: The angled end of securing plate faces to‐
ward shift gate.
– Install both bearing shells -1-.
8-Speed Automatic Transmission 0C8 - Edition 08.2017
Audi Q7 2007 ➤
4. Selector Mechanism Function Unit
51