Service-Policy; No Service-Policy - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Traffic Conditioning
The service commands attach a defined policy to a directional interface. Only one policy may be
assigned at any one time to an interface in the inbound direction. DiffServ is not used in the
outbound direction.
This set of commands consists of service addition/removal.
The CLI command root is

service-policy

This command attaches a policy to an interface in the inbound direction. The <policyname
parameter is the name of an existing DiffServ policy. This command causes a service to create a
reference to the policy.
Note: This command effectively enables DiffServ on an interface in the inbound direction. There
is no separate interface administrative 'mode' command for DiffServ.
Note: This command fails if any attributes within the policy definition exceed the capabilities of
the interface. Once a policy is successfully attached to an interface, any attempt to change the
policy definition, that would result in a violation of the interface capabilities, causes the policy
change attempt to fail.
Format
Modes
Note: Only a single policy may be attached to a particular interface at any time.

no service-policy

This command detaches a policy from an interface in the inbound direction. The <policyname>
parameter is the name of an existing DiffServ policy.
Note: This command causes a service to remove its reference to the policy. This command
effectively disables DiffServ on an interface in the inbound direction. There is no separate
interface administrative 'mode' command for DiffServ.
Format
Modes
Quality of Service (QoS) Commands
Assign a DiffServ traffic conditioning policy (as specified by the policy
commands) to an interface in the incoming direction
service-policy.
service-policy in <policymapname>
Global Config
Interface Config
no service-policy in <policymapname>
Global Config
Interface Config
202-10102-01, May 2005
>
10-23