Service-Policy - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

14.5.1 service-policy

This command attaches a policy to an interface in the inbound direction. The
<policyname>
command. This command causes a service to create a reference to the policy.
Policy-Map
Note: This command effectively enables DiffServ on an interface in the inbound
Note: This command fails if any attributes within the policy definition exceed the
Format
Modes
Note: You can only attach a single policy to a particular interface at any time.
14.5.1.1 no service-policy
This command detaches a policy from an interface in the inbound direction. The
<policyname>
command.
Policy-Map
Note: This command causes a service to remove its reference to the policy. This
Format
Modes
14-24
parameter is the name of an existing DiffServ policy; it is defined by the
direction. There is no separate interface administrative 'mode' command
for DiffServ.
capabilities of the interface. Once a policy is successfully attached to an
interface, any attempt to change the policy definition, that would result in a
violation of the interface capabilities, causes the policy change attempt to
fail.
service-policy in <policyname>
Global Config
Interface Config
parameter is the name of an existing DiffServ policy; it is defined by the
command effectively disables DiffServ on an interface in the inbound
direction. There is no separate interface administrative 'mode' command
for DiffServ.
no service-policy in <policyname>
Global Config
Interface Config
v1.0, February 2007
Quality of Service (QoS) Commands