Fns Adjusting The Stapling Position (Stapling-And-Folding) (Fn-6 Only) - Minolta Di551 Service Manual

[21] FNS Adjusting the stapling position
(stitch-and-fold) (FN-6 only)
Caution: Do not use hands to move stapler unit
to horizontal direction.
(Otherwise the belt and the gear teeth
skipping may occur.
1. Tool
• Screwdriver (Phillips)
2. Adjustment method
a. Preparation
Step
Execute stapling and check whether the
paper edge is parallel to the virtual line con-
necting the two staples or whether the
amount of discrepancy is within specifica-
tion.
Spec value: within 1mm for the amount of
discrepancy
1
Parallel
If the amount of discrepancy for the booklet
is out of spec, perform the following adjust-
2
ment:
Operation
Stapler
Within 1mm
2-128
b. Adjustment
Step Operation
Make sure that the "Adjusting the mount
location of the alignment plates / U" and
1
"Adjusting the mount location of the align-
ment plates / L" are finished.
Open the front door and pull out the stacker
2
unit.
Take off the stapler unit cover.
3
Loosen the three screws securing the
alignment plate and adjust it using the mark
as a guide.
3
Upper edge
4
4
3
3
1. Alignment plate /L
2. Screws
3. Mark
4. Parallel
After the adjustment, retighten the three
screws, execute stapling, and then check
5
that the aligned position is within the spec-
ification range.
ADJUSTMENT
1
2
Lower edge