Minolta Di551 Service Manual page 340

NO Part name
70 FNS stapler/front
71 FNS stapler/rear
72 FNS shift motor
73 FNS exit opening open/close motor
74 FNS folding knife motor
75 FNS By-pass SD
76 FNS DM gate SD
77 PI sheet feed clutch/U
78 PI feed roller unit/A
79 PI feed roller unit/B
80 PI reverse robber unit
81 PI torque limiter
82 PI sheet feed clutch/L
83 PI feed roller unit/A
84 PI feed roller unit/B
85 PI reverse robber unit
86 PI torque limiter
87 Trimmer knife
Punched holes
88
(2 holes)
Punched holes
89
(3 holes)
Punched holes
90
(4 holes)
91 -
92 ADF feed roller
93 ADF Separation roller
94 ADF double-feed prevention robber
95 ADF double-feed prevention roller
ADF paper exit solenoid
96
ADF feed clutch
97
ADF reverse solenoid
98
Maximum
Counting condition
count
99999999 1 is counted each time a copy is ejected in sta-
pling front 1-point stapling, stapling 2-point sta-
pling, or middle binding mode.
1 is counted each time even-numbered paper is
ejected.
1 is counted each time large size stapling (A4R/
8.5x11R or larger) job starts. 1 is counted each
time paper is ejected from each section. 1 is
counted each time stitch and fold or folding job
starts.
1 is counted each time one set of papers in sta-
pling/folding, folding, or three-holding mode is
ejected.
1 is counted each time one set of papers in DM
folding mode is ejected.
Counted each time one paper is ejected in three-
holding mode
Counted each time are paper is fed into PI/U
Counted each time one paper is fed into PI/L
1 is counted each time knife movement is made
Number of ejected papers with the punch mode
selected
Not used
Number of originals passes in all modes
1 is counted each time one original passes in the
double side or the mixed mode
single side: Number of originals passes in every
single side mode count
double side: Number of originals passes in every
double side mode x3 counts
1 is counted each time one original passes in the
double side or the mixed mode
2-43
ADJUSTMENT