Radf Paper Skew Adjustment - Minolta Di551 Service Manual

Open the RADF and loosen the six screws
illustrated.
5
Screws
Close the RADF and loosen the nut of skew
6
adjustment screw.
Turn the skew adjustment screw to adjust
the skew.
For the skew pattern A:
Turn the skew adjustment screw coun-
terclockwise and move the RADF until it
7
reaches the tip of the screw.
For the skew pattern B:
Turn the skew adjustment screw clock-
wise.
Make a copy to check the skew.
8
Fasten the skew adjustment screw with its
9
nut.
Fasten the RADF securing screws (9, with
10
6 in front and 3 in rear).
Make adjustment by repeating steps 3 to 9
until the skew becomes within the standard
11
value.
Use two screws to install each of the two
12
stoppers.

[11] RADF paper skew adjustment

1. Face side of original paper skew adjustment
Note: Perform this adjustment after completing
Screws
Step
1
2
3
2-114
the RADF skew adjustment described in
the previous page.
2
1
4
1. Registration roller
2. Screw
3. Registration roller bracket
4. Jam access cover
Operation
Make a copy in the single sided to single
sided copy mode, then check the skew of
the original. (Either pattern A or B)
Image
Copy paper
Paper skew pattern A
Paper skew pattern B
Open the Jam access cover.
Loosen the retaining screw to release the
registration roller bracket.
ADJUSTMENT
3