Adjusting The Hole Positions For Hole Punch (Fn-105 Only - Minolta Di450 Service Manual

1.6.9

Adjusting the Hole Positions for Hole Punch (FN-105 only)

Rev. 1.1/10.00
8. Fold the copy in half to check that holes are in
correct alignment with each other.
Specifications: 0 ±2 mm
If the specifications are not met, adjust the hole
positions for Hole Punch.
1. Open the Top Cover of the Finisher and
loosen the screw that secures the Hole Punch
Guide Plate.
Slide the green handle to the front or rear to
adjust the position of holes for Hole Punch.
2. Tighten the screw which has been loosened
in step 1.
Make a copy again and check for correct hole
positions. If the specifications are not still met,
readjust.
3. After the adjustment has been completed,
close the Top Cover.
I-55
Note
Note
Di450 / Di550