Adjustment Of The 1St/2Nd (23 Cpm Copier Only) Drawer Reference Position - Minolta EP1054 Service Manual

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13

(7) Adjustment of the 1st/2nd (23 cpm copier only) Drawer Reference Position

Requirement
1074D089
Important
• If the Paper Tray of the Drawer needs to be moved for adjustment, make sure that it is
moved straight, not slantwise (as skewed feeding of paper could result).
1139D027AA
1139D028AA
• Ready a test chart (A3 or 11" × 17") as shown on the
left. Draw a line on the chart at a point 20 mm from
the right edge as shown.
• Dimension A on the copy should measure
20 ± 2.0 mm.
1. Place the test chart face down on the Original
Glass and align its rear left corner with the
marker on the Original Width Scale on the left side
of the platen.
Then, lower the Original Cover.
2. Using the 1st Drawer, make two full size copies.
(Use A3 or 11" × 17" paper.)
3. Using the second copy, compare the position of the
reference line on the copy with that on the test
chart.
4. If the line does not meet the requirement, slide out
the 1st Drawer, loosen the four screws shown on
the left, and move the Paper Tray as necessary to
the front or rear.
5. Using the same steps (1 through 4), adjust the ref-
erence position of the 2nd Drawer.
NOTE
If dimension A on the copy is smaller than 18 mm,
move the Paper Tray to the rear. If it is more than 22
mm, move the Paper Tray to the front.
D-60