Original Feed/Conveyance/Exit Section; Replacing The Pickup Roller And Conveyance Roller Rubber - Minolta Di551 Service Manual

EDH

ORIGINAL FEED/CONVEYANCE/EXIT SECTION

[1] Replacing the Pickup Roller and Con-
veyance Roller Rubber
Caution:
Make sure power cord of the main unit has
been unplugged from the wall outlet.
a. Procedure
(1) Open the Jam access cover.
(2) Remove three stop rings, shift each of the two
bearings outward and detach them.
(3) Remove the pickup roller assembly to detach the
pickup roller.
(4) Remove the pickup roller rubber from the pickup
roller.
1
2
1
4
3
5
1. Stop ring
2. Bearing
3. Pickup roller
4. Pickup roller rubber
5. Jam access cover
(5) Remove four stop rings, and shift the gear (with
a pin) and bearing outward.
(6) Shift the original feed roller assembly to the left
until it stops and lift it up to remove it.
(7) Remove the gear (with a pin) and remove the
original feed roller.
1
2
3
1-P-4
(8) Remove the original feed roller rubber from the
original feed roller.
1
6
3
5
4
3
Paint mark
1. Jam access cover
2. Sensor arm
3. Stop rings
4. Gear (with a pin)
5. Original feed roller rubber
6. Original feed roller
7. D-cut unit
8. Bearing
9. Original feed roller shaft
(9) Reinstall the above parts following the removal
procedure in reverse.
Caution1: Make sure that the original feed roller
is installed in the correct direction.
Caution2: Install the D-cut shaft of the original
feed roller assembly while inserting it
in the receiver side.
Caution3: Make sure not to damage the sensor
arm during installation.
2
7
3
8
9