Minolta Di551 Service Manual page 300

35 Finisher Punch Punch vertical position
Adjust- Adjustment adjustment
ment
Punch horizontal position
36
adjustment
Punch registration loop
37
adjustment
38 Tray Centering Adjustment
39 Adjusting the LCT Paper Feed Roller Pressure
40 Paper up/down Plate Horizontal Adjustment
41 Skew Adjustment
42 Tray Spring pressure adjustment
43 RADF Mounting Position Adjustment
44 RADF Skew Adjustment
45 RADF Paper Skew Face side of original paper
Adjustment skew
Back side of original paper
46
skew
47 PI Centering adjustment
48 PK Adjusting the tilt of the punch hole position
49 PK Adjusting the punch hole vertical position
50 Drum Count Reset
51 Developer Count Reset
52 Web Counter Reset
Caution: Replacing the image control board
• When a damaged image control board is replaced, the memory board on this board must be used on the
new image control board.
Only when the memory board is damaged, use a new memory board on a new control board.
Since the new memory board does not have adjustment data, the all adjustments are required. Before mak-
ing the all adjustments, make the "47mode-92(output) " setting to make the new memory board effective.
• After making any adjustment, make the "47mode -96 (output) setting". After made the "47mode-96 (output)"
setting, the adjustment data is saved.
• However, the "47mode-92" and -96" settings are protected to prevent them from careless operation. In order
to make "47mode -92" and -96" settings using the saved adjustment data, the protection must be disabled.
For the unprotection method, contact the service section at the authorized distributor.
2-82
36
2-82
2-83
2-101
O
2-104
2-105
2-107
2-108
O
2-112
2-113
2-114
2-115
2-137
2-133
2-135
2-40
O
2-40
25
O
2-40
2-3
ADJUSTMENT
O O O
O O O O
O O O
O O
O O
O O
O O
O O
O
O
O
O
3
1
2
O